With no actual tone present, there may be a low-level “idle tone”. If this happens, open the system tray driver icon and click on the little speaker volume symbol near the upper center. However, on Windows XP systems the custom driver inappropriately mixes Front channel signals into the other channels, and Back into Side. Note that if you simply set the desired rate in Daqarta without setting it in Windows or the custom control panel, you’ll just get a simulated rate via Windows sample rate conversion. The information provided within this website is supplied “as is” and without warranty of any kind, expressed or implied, including but not limited to any implied warranties of merchantability, fitness for any particular purpose, or non-infringement. This device is available from multiple suppliers.

Uploader: Gomi
Date Added: 3 August 2015
File Size: 25.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37037
Price: Free* [*Free Regsitration Required]

Neither of these quirks would be cause for concern under normal use, since the frequencies involved are far below the audible range.

Click OK and you are ready to start Daqarta. The actual manufacturer is not stated. In some of our email messages we use a lick-through URL linked to content on the Cmedia website.

See the CM 5. The overall low frequency response is excellent; the Line In -3 dB point is below 1 Hz. After you run Auto-Calibrationyou should perform a Full-Scale Range calibration and enter each Input or Output range as a negative number. The Generator mexia set to produce a biphasic Pulse waveform, such that the positive mfdia preceded the negative phase, and there was a dwell time at zero before the next pulse.

To achieve a Gold competency level, Solvusoft goes through extensive independent analysis that looks for, amongst other qualities, a high level of software expertise, a successful customer service track record, and top-tier customer value. The frequency had an exact integer number of signal cycles in the samples used for the FFTso it and all harmonics fell exactly on spectral lines.


Cmedia takes your privacy very seriously. The 20 kHz crosstalk was likewise measured on the Left In mwdia as the difference between the 1 kHz peak and any 20 kHz peak that leaked through.

Note that neither the X-Fi nor Xonar U7 allow Daqarta to change sample rates directly, but there is no obvious indicator of that. Why do we collect your personal information? To unlock the separate sliders of a pair, click on the lock icon at the bottom between ‘L’ and ‘R’.

There is a separate headphone jack with 50 ohm impedance that can deliver 0. It is highly recommended for those who need to work at high frequencies, and for anyone else who doesn’t mind the 2x reduction in frequency resolution due to using the higher rate with Daqarta’s fixed sample spectra.

Please take a moment to read the following to learn more about our information practices, including what type of information is gathered, how the information is used and for what purposes, to whom we disclose the information, and how we safeguard your personal information.

You must disable Line before you can enable Microphone and vice-versa.

Solvusoft: Microsoft Gold Certified Company

By continuing to browse, you are agreeing to our use of cookies as explained in our Privacy Policy. Maximum input and output voltages are slightly below the sudden onset of a sharp distortion rise indicative of clipping, as seen in the spectrum which is much more sensitive than visual detection of clipping on the waveform.

Alternatively, instead of the Xonar control panel, users of Vista and later Windows versions can right-click the normal Windows speaker icon in the system tray and set Playback devicesthen Speaker – Xonar U7 then Properties at the bottom of the dialog, then Advancedand select “16 bit” at your chosen sample rate typically, or First, make sure you have 6 or 8 channels selected under Output Device – Analog Output in the custom driver control panel.


Presumably, in any stationary setup this would not arise.

USB Audio,PCIe audio,USB audio ic,USB sound chip–C-Media Electronics, Inc.

Then start Daqarta and set that same sample rate there. In the lower ‘Rec’ panel, make sure only ‘Line In’ is selected. These are not necessarily the levels for lowest distortion, but are the highest “useful” levels.

The Mic In is mono-only. If you also use this unit for other applications like music listening, you should make sure that this option is off when using Daqarta. Line In Max sens 0. The high frequency response measurements were repeated using a Hz sample rate. It not only has superbly low noise and distortion, but the best frequency response as well.

These are loopback measurements, and it turns out that the droopy XP curve is entirely due to problems with the output; the Line In response is very flat, as shown by the -3 dB value of Hz in the Comparison Table. Before starting Daqarta, right-click on the speaker icon in the system tray and select Recording Devices.

As with the above 5. An icon with a small blue-and-yellow musical note will appear in the Windows system tray whenever you plug in the device.