Keying ensures that the pin-1 wire in the cable connects to pin 1 in the connectors on both ends. When you disconnect an interface cable, take care to grasp the cable connector, rather than the cable itself, to avoid stress on the cable. Only trained service technicians are authorized to open the system and access any of the components inside the system. See the drive documentation in your upgrade kit for information on configuring drives for the Cable Select setting. To gain access to the front-panel insert, you might need to remove a device. If you are installing a tape backup unit TBU , it must be installed in the second bay. To install and configure a SCSI drive, follow the guidelines in the following subsections.

Uploader: Kigakus
Date Added: 27 August 2018
File Size: 23.72 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 53287
Price: Free* [*Free Regsitration Required]

To gain access to the front-panel insert, you might need to remove a device.

For internal SCSI drives, termination is configured automatically. See the documentation provided with any optional SCSI drive you purchase for information on disabling termination.

When you disconnect an interface cable, take care to grasp the cable connector, rather than the cable itself, to avoid stress on the cable. Removing or Installing an Optional Diskette Drive.

You can install an additional 5. After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer start-up:. To powreedge and configure a SCSI drive, follow the guidelines in the following subsections. SCSI interface connectors are keyed for correct insertion.

  F4185 PRINTER DRIVER DOWNLOAD

For instructions, see the documentation that accompanied the ac1420. If you are installing a new 5. When replacing the hard-drive cooling shroud, ensure that the cables are properly routed to prevent damaging the cables.

Installing Drives: Dell PowerEdge SC Systems Installation and Troubleshooting Guide

Keying ensures that the pin-1 wire in the cable connects to pin 1 in the connectors on both ends. See the drive documentation in your upgrade kit for information on configuring drives for the Cable Select setting. See ” Installing an Expansion Card ” in “Installing System Components” for instructions about installing the card and routing the cables. Only trained service technicians are authorized to open the system and access any of the components inside the system.

Although SCSI drives are installed in essentially the same way as other drives, their configuration requirements are different. When you connect two IDE devices to a single IDE interface cable and configure them for the Cable Select setting, the device attached to the last connector on the interface cable is the primary master or boot device drive 0and the device attached to the middle connector on the interface cable is the secondary slave device drive 1.

If you are installing a tape backup unit TBUit must be installed in the second bay. See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

  DESKJET D1320 WINDOWS XP DRIVER DOWNLOAD

Installing Drives

After installing the drive and adapter, the removing and installing procedures are the same as the other hard drives. The fourth hard drive is installed in the 5. Drive Locations Inside the System.

Only trained service technicians are authorized to open the system cover and access any of the components inside the system. If you are installing a fourth hard drive in the 5. SCSI logic requires that termination be enabled for the two drives at opposite ends of the SCSI chain and disabled for all drives in between. To boot the system ddll a vell drive or drive array, the drive s must be connected to the appropriate controller:.

The drive or device from which the system boots is determined by the boot order specified in the System Setup program. Because Cable Select is the default setting, you do not need to set any additional drives as a primary or secondary drive. SCSI devices installed by Dell are configured correctly during the manufacturing process.