When you clear the CMOS you must have the computer unplugged. Please connect the red power connector wire to the pin1 position. As I can not get the computer to see the new hdd I can not load the sata software. After skimming this entire thread I am not sure I know if you just assembled this computer or simply replaced a drive. Was the power supply previously used in this setup? I went to the Western Digital site via the link posted in Response The POST screen loads extremely slow, like it is not able to find what it is looking for.

Uploader: Grotaxe
Date Added: 12 January 2005
File Size: 31.14 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63086
Price: Free* [*Free Regsitration Required]

I was stuck on how to install things. RAID 0 can put two hard drives in parallel to improve performance access times and data throughput. You must log in or register to reply here.

When you get a screen asking what type of install you want to perform, choose custom.

Gigabyte Drivers | Page 11 – TechSpot

So your K8U probably does also. You gotta love it I’m not using RAID for any of my drives. The old hdd is a WD but it is totally inop. Don’t have an account?

  ADAPTEC AHA 2940UW PRO DRIVER DOWNLOAD

Thanks Mike, appreciate it.

If it was IDE, did you install Sata drivers? Today I decided to install a Floppy drive.

Gigabyte Technology GA-K8NSC-939, Socket 939, AMD Motherboard

You need to slipstream the Ag-k8nsc-939 drivers. Can anyone offer any suggestions or an explanation as to how to add the drivers to the xp disc. Otherwise the system assumes you just want to use your hard drive s in the traditional, non-RAID setup. Damage due to improper installation.

Did you try another molex connection? It allows you to limit access to the system and Setup, or just to Setup. I have heard from some folks that S. At that time you supply a floppy disk with the SATA files on it.

Less than an Hour Ago Time Zone: Set to maximum time allowed, which may be 5 seconds. Trending Price New. Entering the Q-Flash utility: After that, it’s no different that PATA. Other than that all bios settings are the same.

  MAC 3945ABG DRIVER DOWNLOAD

User Control Panel Log out. What a strange trip it has been with this computer. After that, the driver will not have to be installed. Any sugestions or a different motherboard recommenations would be appreciated. Then click on the left selection bar and select “4CH Speaker” to complete 4 channel audio configuration.

Gigabyte GA-K8NSC-939 User Manual

Below is a link to download all the drivers for that board. Opteron Socket Computer Processors.

Reverse the installation steps when you wish to remove the DIMM module. As well, because of the age of the computer, we changed the power supply and the data cable for the HDD.

You might need to hit F6 at the beginning of the setup to load the motherboard chipset drivers.