Click Yes and remove the driver CD while restart your system to complete the installation. To avoid possible static electricity discharge during the installation, please follow the guidelines below:. April Copyright and Trademarks The information of the product in this manual is. Remove the slot bracket from an available PCI slot. Guide to More information. All hardware and software necessary to replace your. Replace the slot bracket holding screw to secure the board.
|Date Added:||3 September 2016|
|File Size:||22.96 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Table of Contents 1. Setup the RAID array prior to driver installation.
The task menu consists of all operation entry points while the array and device view windows graphically display the result of operations and the current configuration of RAID and related devices.
After installing the board, boots up your system.
If your computer regularly performs random read requests, choose a smaller stripe size. Inic12x Enter to continue and follow on-screen instructions to complete driver installation.
Initio INIC162x S-ATA Raid Controller drivers for Windows 7 x64
For Existing New Windows installation 1. The easy-to-follow More information. Remove the driver CD while restart your system to complete the installation. Installation Static Electricity Precaution One of the routine precautions you must be aware of when working with computer components is the problem of static electricity discharge.
Perform the below steps to initialize a logical drive by using the initialize selection, continue the steps will destroy all the data on the hard disk drive. Striping will destroy existing data on the hard disk drives. Check Search for the best driver for your device Recommendedthen click Next.
This document contains materials protected by International. It achieves burst data More information. All brand or product names mentioned More information. At the Windows Setup screen, press F6 to install the driver. RAID 1 will limit the disk space to the smaller size of the drive and reduced performance during rebuilds. For Existing Windows 98SE installation 1.
Eata the board and boot up your system. Press S, select Other, then press Enter. Select Automatic search for a better driver [Recommended], click Next, 9. Follow on-screen instructions to complete the installation.
Insert the driver diskette and press Enter. Press Enter to continue and follow the on screen instructions to complete driver installation. Introduction Quick Installation Guide The esata 3. To make this floppy disk, copy the contents of the Floppy folder, found on the driver CD, onto a blank floppy disk then follow the directions below.
Data just bunches as one logical drive from two physical disks. All brand or product names mentioned are More information.
Initio Corporation – INIC/22/23
To install the card, carefully align the card’s bus connector with the selected PCI slot on the motherboard. RAID configurations More information. Push the board down firmly, but gently, until it is well seated. It achieves burst data.