If it is necessary to touch elements on the PWB with your hand, make sure your body is properly grounded. Replace the image transfer unit. Installing a fuse of a different make or rating could lead to a possi- ble fire. Power supply on 1. Remove the rear cover – 2 screws. This test prints five pages-one page for each color and the last page with all four colors. LED light passage port Light passing through this port is used to determine when there is no toner.

Uploader: Kagakora
Date Added: 13 February 2007
File Size: 36.87 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63673
Price: Free* [*Free Regsitration Required]

Remount the toner cartridge. The test will run until paper is consumed, printer turned off, or paper jam occurs. Laser light is emitted, and printing starts in the main scan direction.

And even though this should go without saying, super glue should only be used with great caution and care. Lift up the bottom end of the lower paper take-up guide and remove it from the clamping of the timing roller section. Remove the 1 3 set screws for the rear cover. This data is read by the CPU for controlling the optimum image transfer bias and fusing temperature.

Make sure no power is being supplied to the unit. Watch list is full. OPCdrum This uses a laser beam to create the electrostatic latent image, and developing is performed by the developing roller. Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

  39GAMES BIKE GAMES 250 SKILLED DRIVER

This measurement detects the strength and duration of the reflected light as the toner stirring blades also block the reflected light. This amount is subject to change until you make payment. Image transfer belt offset. Remove the 3 connectors for the rear rack bearing and the 4 set screws.

Are the light emitting and receiving ports for the OHP sensor dirty? Multipurpose paper take-up solenoid SL8 C-3 Upper tray The drive force that has been supplied from the transport motor is conveyed as follows.

Solvusoft: Microsoft Gold Certified Company

If d, use curtains or other mea- sures to protect the printer from direct sun- light. Remove 5 screws one of which is groundand 2 connectors. Remove the 1 connector for the pressure roller release sensor and the 1 set screw. Paper take-up roller Feeds the paper in the multipurpose tray. Before removing connectors from a PWB, make sure the printer has been unplugged.

Open the top-right cover by pushing the button just underneath and to the front of it and remove the screw that was behind the button. Handle fl power cord with care and never use a multiple outlet.

  3DLABS OXYGEN GVX1 PRO DRIVER

Paper size magcolor Detects the size of the paper in the cassette. Remove the hook for the paper size switch and pull out the 1 con- nector.

4 Toner Refill for Konica Minolta QMS MagiColor DL Color Printer | eBay

Paper empty sensor Detects when there is no paper in the cassette tray. Remove the front cover.

E Media jam transfer image transfer section Problem Check Result Corrective action The paper is stopped at the timing roller sec- tion. The switching arm 1 lowers and the paper is taken in by the mailbin. Never tamper with the adjustment of the variable resistor VR1D. Refer to the dimensions in the following diagrams when installing. Doing so could result in an electric shock.

Drum Reset Kit Konica Minolta QMS Magicolor Color Printer | eBay

Refer to maagicolor draw- ing below right. Fuse system Number of black images 4, prints K toner low 6, prints K toner empty Y toner New unit detection: Remove the insulation sheet.

Sleep mode The heater mode is turned off when a sleep mode command is received from the controller.